User guide

Managing the Directory Structure of the CMM (Non-Redundant) Managing CMM Directory Content
page 4-12 OmniSwitch 7700/7800/8800 Switch Management Guide April 2006
To save the running configuration to the working directory, enter the copy running-config working or
write memory command at the prompt, as shown:
-> copy running-config working
or
-> write memory
The above commands perform the same function. When these commands are issued the running configura-
tion, with all modifications made, is saved to a file called boot.cfg in the working directory.
Note. This command will not function if the switch is running from the certified directory. See “Where is
the Switch Running From?” on page 4-4 for an explanation.
The copy running-config working and write memory commands are described in detail in the
OmniSwitch CLI Reference Guide.
Note. The saved boot.cfg file will be overwritten if the takeover command is executed after the copy
running-config working or write memory commands, in an OmniSwitch set up with redundant CMMs.