User guide

Managing Switch User Accounts Configuring Privileges for a User
OmniSwitch 7700/7800/8800 Switch Management Guide April 2006 page 7-11
Configuring Privileges for a User
To configure privileges for a network administrator account, enter the user command with the read-only
or read-write option and the desired CLI command domain names or command family names. The read-
only option provides access to show commands; the read-write option provides access to configuration
commands and show commands. Command families are subsets of command domains.
If you create a user without specifying any privileges, the user’s account will be configured with the privi-
leges specified for the default user account.
Note. Privileges cannot be configured for users with end-user profiles; privileges and profiles are mutu-
ally exclusive.
Command domains and families are listed here:
Domain Corresponding Families
domain-admin file telnet dshell debug
domain-system system aip snmp rmon webmgt config
domain-physical chassis module interface pmm health
domain-network ip rip ospf bgp vrrp ip-routing ipx ipmr ipms
domain-layer2 vlan bridge stp 802.1q linkagg ip-helper
domain-service dns
domain-policy qos policy slb
domain-security session avlan aaa