User guide

Using the CLI Multiple User Sessions
OmniSwitch 7700/7800/8800 Switch Management Guide April 2006 page 5-21
Listing Your Current Login Session
In order to list information about your current login session, you may either use the who command and
identify your login by your IP address or you may enter the whoami command. The following will
display.
-> whoami
Session number = 17
User name = admin,
Access type = telnet,
Access port = NI,
IP address = 123.33.101.13,
Read-only domains = None,
Read-only families = ,
Read-Write domains = All ,
Read-Write families = ,
End-User profile =
This display indicates that the user is currently logged in as session number 4, under the username
“admin,” using a Telnet interface, from the IP address of 123.33.101.13.
Session Number The session number assigned to the user.
User name User name.
Access type Type of access protocol used to connect to the switch.
Access port Switch port used for access during this session.
Ip Address User IP address.
Read-only rights The hexadecimal value of privileges configured for the user.
Read-Write rights The hexadecimal value of privileges configured for the user.
Read-only domains The command domains available with the user’s read-only access. See
the table beginning on page 5-6 for a listing of valid domains.
Read-only families The command families available with the user’s read-only access. See
the table beginning on page 5-6 for a listing of valid families.
Read-Write domains The command domains available with the user’s read-write access. See
the table beginning on page 5-6 for a listing of valid domains.
Read-Write families The command families available with the user’s read-write access. See
the table beginning on page 5-6 for a listing of valid families.