User guide

Managing Redundant CMMs Managing CMM Directory Content
page 4-22 OmniSwitch 7700/7800/8800 Switch Management Guide April 2006
To synchronize the secondary CMM to the primary CMM, enter the following command at the prompt:
-> copy flash-synchro
The copy flash-synchro command is described in detail in the OmniSwitch CLI Reference Guide.
Note. When synchronizing the primary and secondary CMMs, it is important to remember that the
boot.params file and the switch date and time are not automatically synchronized. See the your Getting
Started Guide for information on the boot.params file, and Chapter 2, “Managing System Files,” for
information on setting the switch date and time. The date and time are synchronized using the system
time-and-date synchro command.
Synchronizing the System Date and Time
To synchronize the system date and time, use the system time-and-date synchro command. This
command synchronizes the secondary CMM date and time to the primary CMM date and time.
Enter the command as shown:
-> system time-and-date synchro