User guide

Managing CMM Directory Content Managing the Directory Structure of the CMM (Non-Redundant)
OmniSwitch 7700/7800/8800 Switch Management Guide April 2006 page 4-17
Show Currently Used Configuration
When a switch is booted, the certified and working directories are compared. If they are the same, the
switch runs from the working directory. If they are different, the switch runs from the certified directory.
A switch running from the certified directory cannot modify directory contents. (This topic is covered in
“Where is the Switch Running From?” on page 4-4.)
To check the directory from where the switch is currently running, enter the following command:
-> show running-directory
CONFIGURATION STATUS
Running CMM : PRIMARY,
CMM Mode : DUAL CMMs,
Current CMM Slot : A,
Running configuration : WORKING,
Certify/Restore Status : CERTIFY NEEDED
SYNCHRONIZATION STATUS
Flash Between CMMs : NOT SYNCHRONIZED,
Running Configuration : SYNCHRONIZED,
NIs Reload On Takeover : ALL NIs
The command returns the directory the switch is currently running from (working or certified) and which
CMM is currently controlling the switch (primary or secondary), as well as the synchronization status and
the certify status.
The show running-directory command is described in detail in the OmniSwitch CLI Reference Guide.