User guide

Setting Up Power over Ethernet Hardware Installing and Managing Power over Ethernet (PoE)
page 3-12 OmniSwitch 7700/7800 Hardware Users Guide April 2005
2 Attach the flanges to the power shelf using the Phillips-head screws provided. Be sure to tighten each
of the screws firmly using a Phillips screwdriver.
3 After both rack-mount flanges are secured to the unit, mark the holes on the rack where the power shelf
is to be installed.
4 Lift and position the power shelf until the rack-mount flanges are flush with the rack post.
5 Align the holes in the flanges with the rack holes that were marked in step 3.
6 Once the holes are aligned, insert a rack mount screw (not provided) through the bottom hole of each
flange. Tighten both screws until they are secure.
Note. Be sure to install the screws in the bottom hole of each flange, as shown, before proceeding.
7 Once the screws at the bottom of each flange are secure, install the remaining two rack mount screws.
Be sure that all screws are securely tightened.
1
23
4
E
EQUIPPED
PL
Y CORDS
.
E
CTRIC
O
WER SUPPL
Y
UNIT
.
PEUT
R
DON
R
EVENIR LE
S
R
ANCHEZ
T
OUS
C
ORDONS
MENT
A
TION
N
T DE F
AIRE
E
PARA
TION.