User guide

Network Interface (NI) Modules GNI Modules
OmniSwitch 7700/7800 Hardware Users Guide April 2005 page 5-17
Installing MiniGBIC Connectors
If you are installing an OS7-GNI-U12 module, you must install Miniature Gigabit Interface Converters
(MiniGBICs) as required. OS7-GNI-U12 modules provide ports for up to twelve MiniGBICs. These Mini-
GBIC are packaged separately.
Note. Be sure you have eliminated ESD by using the provided grounding wrist strap. Refer to “Using the
Grounding Wrist Strap and Chassis Grounding Lug” on page 5-24 for more information.
To install a MiniGBIC follow the steps below.
1 When inserting a MiniGBIC, be sure that the hinged face is closed.
2 Slide the MiniGBIC straight into the slot until the module clicks firmly into place.
3 Push the MiniGBIC into the slot until it clicks into place.
Note. The diagram below is a representation only; the physical appearance of the actual MiniGBIC may
vary.
Caution. The MiniGBIC should slide in easily. Do not force it into the slot. If any resistance is encoun-
tered, ensure the MiniGBIC is aligned properly. Forcing the MiniGBIC into the slot can damage the unit,
as well as components on your GNI module.
Note. To remove a MiniGBIC, you must first open the MiniGBIC’s hinged face to approximately ninety
degrees. Then, grasp the hinged face and carefully pull the MiniGBIC straight out of the slot.
LIN
K
A
C
T
LINK
A
C
T
LINK
A
C
T
LINK
A
C
T
8
7
6
MiniGBIC Module
MiniGBIC Slot
GNI Module