Technical data

IPX Configuration 81
Perform the following configuration in VLAN interface view.
By default, type 20 broadcast packets are not forwarded.
Displaying and Debugging IPX
After configuration, execute display command in any view to display the operation
of the IPX configuration, and to verify the effect of the configuration. Execute
debugging command in user view to debug IPX. Execute reset command in user
view to clear IPX statistics.
IPX Configuration
Example
In this example, Switch A, with the node address of 00e0-fc01-0000, is connected
to Switch B, with the node address of 00e0-fc01-0001, through an IPX network.
There is a server installed with NetWare 4.1 and assigned the network number of
2. On the server, the packet encapsulation format is set to Ethernet_II. The client is
a PC with the network number of 3 and the packet encapsulation format of SNAP.
Table 39 Enabling or Disabling Forward IPX Type 20 Broadcast Packets
Operation Command
Enable the forwarding of type 20 broadcast
packets
ipx netbios-propagation
Disable the forwarding of type 20 broadcast
packets
undo ipx netbios-propagation
Table 40 Displaying and Debugging IPX
Operation Command
Display the information of IPX on one or all
VLAN interfaces
display ipx interface [ vlan-interface
vlan_id ]
Display the IPX packet statistics information display ipx statistics
Display the IPX service information table display ipx service-table [ inactive | name
name | network network | order { network |
type } | type service-type ] [ verbose ]
Display the IPX routing information display ipx routing-table [ network [
verbose ] | protocol { default | direct | rip |
static } [ inactive | verbose ] | statistics |
verbose ]
Clear the IPX statistics information reset ipx statistics
Clear the IPX routing table information reset ipx routing-table statistics protocol {
all | default | direct | rip | static }
Disable/Enable IPX SAP debugging [ undo ] debugging ipx sap [ packet [
verbose ] | event ]
Disable/Enable IPX packet debugging [ undo ] debugging ipx packet [
vlan-interface vlan_id ]
Disable/Enable IPX ping debugging [ undo ] debugging ipx ping
Disable/enable IPX RIP debugging [ undo ] debugging ipx rip { packet [
verbose ] | event }
Disable/Enable IPX triggered updates
debugging
[ undo ] debugging ipx rtpro-flash
Disable/Enable IPX interface debugging [ undo ] debugging ipx rtpro-interface
Disable/Enable IPX routing table debugging [ undo ] debugging ipx rtpro-routing