Technical data

76 CHAPTER 4: NETWORK PROTOCOL OPERATION
Perform the following configuration in VLAN interface view.
By default, the forwarding delay on the VLAN interface is one tick.
Configuring IPX RIP to Import Static Routes By importing static routes, the
switch includes the static routes in the IPX RP update messages. Perform the
following configuration in system view.
By default, IPX RIP does not import static routes.
Note that RIP imports only active static routes; inactive static routes are neither
imported nor forwarded.
Configuring IPX SAP
After IPX is enabled on VLAN interfaces, the system automatically enables SAP.
You can configure SAP parameters and service information by performing the
tasks described in the following sections:
■ Enabling and Disabling SAP
■ Configuring the Update Interval of IPX SAP
■ Configuring the Aging Period of IPX SAP
■ Configuring the Size of IPX SAP Update Packets
■ Configuring the GNS Reply of IPX SAP
■ Configuring Static IPX Service Entries
■ Configuring the Maximum Length of the Service Information Reserve-Queue
for One Service Type
Enabling and Disabling SAP On a VLAN interface, SAP is enabled as soon as
IPX is enabled on the interface. You can enable or disable SAP with the following
commands.
Perform the following configuration in VLAN interface view.
Tab le 25 Configuring the IPX Forwarding Delay on the VLAN Interface
Operation Command
Configure the IPX packet forwarding delay on
the VLAN interface
ipx tick ticks
Restore the default forwarding delay undo ipx tick
Tab le 26 Configuring IPX RIP to Import Static Routes
Operation Command
Configure IPX RIP to import static routes ipx rip import-route static
Remove the static routes imported by IPX RIP undo ipx rip import-route static
Tab le 27 Enable/Disable SAP
Operation Command
Disable IPX SAP
ipx sap disable
Enable IPX SAP undo ipx sap disable