Technical data

350 CHAPTER 11: SYSTEM MANAGEMENT
Setting the Source Address of the Trap
Use the following commands to set or remove the source address of the trap.
Perform the following configuration in system view.
Adding and Deleting a User to or from an SNMP Group
Use the following commands to add or delete a user to or from an SNMP group.
Perform the following configuration in system view.
The authentication-mode parameter specifies the use of authentication. The
privacy-mode parameter specifies the use of authentication and encryption. This
parameter is supported only in SNMP V3.
For details, see the Switch 7700 Command Reference Guide.
Creating and Updating View Information or Deleting a View
Use the following commands to create, update the information of views, or delete
a view.
Perform the following configuration in system view.
Setting the Size of an SNMP Packet Sent or Received by an Agent
Use the following commands to set the size of SNMP packet sent or received by an
agent.
Tab le 52 Setting the Source Address of the Trap
Operation Command
Set the Source Address of Trap snmp-agent trap source interface-name
interface-num
Remove the source address of trap undo snmp-agent trap source
Tab le 53 Adding and Deleting a User to or from an SNMP Group
Operation Command
Add a user to an SNMP group snmp-agent usm-user { v1 | v2c } username
groupname [ acl acl-list ]
snmp-agent usm-user v3 username
groupname [ authentication-mod { md5 |
sha } auth_password [ privacy-mod { des56
priv_password } ] ] acl acl-list
Delete a user from an SNMP group undo snmp-agent usm-user { v1 | v2c }
username groupname
undo snmp-agent usm-user v3 username
groupname { local | engineid engine-id }
Tab le 54 Creating and Updating View Information or Deleting a View
Operation Command
Create or update view information snmp-agent mib-view { included |
excluded } view-name oid-tree
Delete a view undo snmp-agent mib-view view-name