Specifications

97
Maintenance
Reassembling the oil case
Reassembling the gas ballast
Reassembling the oil
level sight glass
Reassembling the
seal-holder
Reassembling the motor
side components
Fit the oil case on the frame. Fasten the attachments after making sure that the seal
is positioned in its seal groove (clamping torque 0.8 mdaN (5.8 ft lbs)).
Position the oil case feed-through equipped with the seal in its housing by
centering it on the gas ballast tube. Assemble using the screws.
Equip the adjustment knob with the sleeve and the spring. Position the assembly in
the cover and secure on the oil case feed-through.
Replace the O-ring (included in the seal kit).
Fit the sight glass and assemble with screws (clamping torque 0.3 mdaN
(2.14 ft lbs)).
C1 series pump: The sight glass is made of glass: gradually tighten the
two attachment screws in alternation to avoid placing the sight glass
under stress.
See page 89.
Fit the fan 1/2 sleeve.
Fit the drive key on the motor shaft.
Install the motor coupling sleeve down to the stop on the motor shaft.
Fit the motor on the frame and install the 4 mounting bolts (clamping torque
1 mdaN (7.14 ft lbs)).