Specifications

Changing position of inlet

and exhaust ﬁttings

Disassembling the ﬁttings

Horizontal reassembly

Depending on the types of accessories used and the pumping conditions,

these oriﬁces can be ﬁtted vertically on the pump or horizontally as shown on

the diagram below.

Note: The pump is supplied in conﬁguration A.

Unfasten the attachment screw from

the end ﬁtting to be removed.

Unfasten the end ﬁtting and remove

it from its housing along with the

O-ring. In the case of the inlet end

ﬁtting, also remove the inlet ﬁlter.

Remove the attachment screw

from the lateral cap and

using a wide screwdriver, remove the

cap.

- Position the end ﬁtting in the

corresponding lateral oriﬁce taking care

to ﬁt the O-ring.

Attach the end ﬁtting with the screw.

In the case of the inlet end ﬁtting, ﬁt the ﬁlter at the bottom of the oriﬁce.

- Close unused oriﬁces with plugs and fasten the screws.

In. Exh. In. Exh.