User guide
v /opt/proviso/datachannel/log
rm –rf *log
4. Create backup of the DataChannel directories and do not delete them from the
original location except UBA directories.
5. Install the Alcatel-Lucent 5620 SAM LogToFile 2.3.0.0 Technology Pack. For
more information, see “Installing the technology pack by using the
launchpad” on page 40.
6. Copy the core patches to/opt/proviso/datachannel/state.
7. Start the Topology Editor and load the technology pack from the JAR file.
8. Configure the Accounting and Performance UBAs with the same collector
numbers that you deleted in step 2.
9. Set the APP.FILE_PERIOD parameter value same as the data file polling time.
For example, if the data file polling is at the cycle of every 5 Minutes, set the
value to 300.
10. Save the topology.
11. Run the deployer to complete the installation.
12. Start the Request Editor, set to inactive, and then save.
13. Update the polling time to 5 Minutes or 15 Minutes, set to active, and then
click Save.
14. Run the following commands to restart each DataChannel visual process:
$ cnsw
$ logw
$ amgrw
$ cmgrw
15. Run the dccmd command to start all the DataChannel applications: .
$ dccmd start all
16. Compile the uba profiles.
17. Run the auto-grouping again after the full dump process is completed for the
first time.
Upgrading the Alcatel-Lucent 5620 SAM LogToFile 2.2.0.0 Technology
Pack to Alcatel-Lucent 5620 SAM LogToFile 2.3.0.0
You can upgrade Alcatel-Lucent 5620 SAM LogToFile 2.2.0.0 Technology Pack to
Alcatel-Lucent 5620 SAM LogToFile 2.3.0.0 Technology Pack.
Before you begin
Before you upgrade Alcatel-Lucent 5620 SAM LogToFile 2.2.0.0 Technology Pack to
Alcatel-Lucent 5620 SAM LogToFile 2.3.0.0 Technology Pack, you must first remove
the linking for timeCaptured metric and then remove the timeCaptured metric. The
timeCaptured metric is available in bulk groups InterfaceAdditionStats and
InterfaceStats.
To remove the linking for timeCaptured metric, follow these steps:
1. Source the dataMart.env file by using the following command:
source /opt/datamart/dataMart.env
2. Start the DataMart GUI by using the following command:
pvm &
3. Click the Configuration tab, and then click Request Editor to open the
Request Editor.
54 Alcatel-Lucent 5620 SAM LogToFile 2.3.0.0 Technology Pack Installation and User Guide