User guide

– Accounting UBA
4. Click Run > Run Deployer for Installation to deploy the topology that you
configured.
To configure the Alcatel-Lucent 5620 SAM LogToFile 2.3.0.0 Technology Pack,
follow these steps:
Procedure
1. Load the DataMart environment. To load the shell with the DataMart
environment, follow these steps:
a. Log in to the DataMart server as pvuser.
b. Create new folder DATA_CHANNEL_HOME/scripts/alcatel_5620_sam_log2file.
c. Change your working directory to the DataMart home directory
(/opt/datamart, by default), by using the following command:
$ cd /opt/datamart
d. Load the shell with the DataMart environment, by sourcing the
dataMart.env file, as follows:
$ . /opt/datamart/dataMart.env
Note: After you load the DataMart environment into the shell, the
PVMHOME variable is set to the DataMart home directory, /opt/datamart
by default. These instructions assume that this variable is set.
2. Copy technology-specific files from the DataMart server to the DataChannel
server. Technology-specific files are used to associate a UBA technology pack
with a specific instance of the UBA.
Note: While it is possible to install DataMart and DataChannel on the same
server, in a typical installation these modules are installed on separate servers.
If so, use FTP to copy the technology-specific files. Otherwise, if DataMart and
DataChannel are on the same server, use the cp command to copy the files to
the appropriate DataChannel directory.
To copy technology-specific files to the DataChannel server, follow these steps:
a. Log in to the Tivoli Netcool Performance Manager DataChannel server by
entering the user name and password that you specified when you install
and configuring a DataChannel. The default user name and password are
pvuser and PV.
b. Change your working directory to the DATA_CHANNEL_HOME/scripts/
alcatel_5620_sam_log2file directory by entering the following command,
replacing DATA_CHANNEL_HOME with the DataChannel home directory
(/opt/datachannel, by default):
$ cd DATA_CHANNEL_HOME/scripts/alcatel_5620_sam_log2file
c. Using the FTP utility in text mode, log in to the DataMart server by using
the appropriate user name and password (pvuser and PV, by default).
d. Using the cd subcommand, change your working directory to the
$PVMHOME/APFiles/alcatel_5620_sam_log2file/datachannel/scripts/
alcatel_5620_sam_log2file directory.
e. By using the get subcommand, copy the bulk adapter design files (*.js),
scripts (if any), and other files (if any) from the DataMart server to the
DataChannel server.
f. Exit the FTP utility by entering the bye subcommand.
g. Verify that the technology-specific files are now in the target directory as
follows:
46 Alcatel-Lucent 5620 SAM LogToFile 2.3.0.0 Technology Pack Installation and User Guide