User guide

Alcatel-Lucent 5620 SAM LogToFile 2.3.0.0 Technology Pack installation
directory” on page 39 in the left panel. All the packs are automatically
selected for installation.
7. Clear any technology packs in the list that you do not want to install, and
then click Next.
Note: The prerequisites for technology packs item in the Feature Selection
window is always installed. You cannot clear this item. The Starter Kit is not
included in this item.
Depending on the type of packs you install, you might be presented with
slightly different windows.
8. Click Next to start the installation.
As the stand-alone packs are installed, the Technology Pack Installer displays
the name of each pack and indicates the progress. When the installation
completes, the Technology Pack Install Complete window is displayed.
9. Click Finish to exit the Technology Pack Installer.
10. Go to What to do next section to perform post-installation tasks.
What to do next
After the installation completes, do the following tasks:
Important: A technology pack does not work until it is configured. After you
configure the technology pack, data is collected and reports are populated.
v Populate the family dictionary table as described in “Populating the family
dictionary table.”
v Add a UBA collector as described in“Adding a UBA collector for a UBA pack”
on page 43.
v Configure the technology pack as described in Chapter 7, “Configuring the
technology pack,” on page 45.
Populating the family dictionary table
Use this information to populate the family dictionary table for any new
Alcatel-Lucent 5620 SAM LogToFile 2.3.0.0 installation.
Procedure
1. Change your working directory to the standard directory by using the
following command:
cd $PVMHOME/APFiles/alcatel_5620_sam_log2file/datamart/standard/
2. Provide the run permission to the importLogToFileFamilyDictionary.rmg script
file by using the following command:
chmod +x importLogToFileFamilyDictionary.rmg
3. Source the DataMart environment by using the following command:
.$PVMHOME/dataMart.env
4. Run the importLogToFileFamilyDictionary.rmg script file by using the
following command:
./importLogToFileFamilyDictionary.rmg
Initially, you receive the $Import has started message. When the import is
completed, you see the $Completed import message.
42 Alcatel-Lucent 5620 SAM LogToFile 2.3.0.0 Technology Pack Installation and User Guide