User guide

v Click System > System Firewall > Disable Firewall to disable the firewall.
Disable the firewall temporarily until the installation is complete.
About this task
When you first start the installation program, it presents a non-graphical interface.
The program starts a self-contained web server on the computer. You can then start
a web browser on the computer or on a remote computer and access the graphical
interface. After you enter your settings in the wizard pages, the program stores
your settings in a response file. If you run the installation program again, you can
load your settings from this file into the program instead of entering them again.
Procedure
1. Extract the InfoSvr_v8.7_Linux64.tar.gz file to a location of your choice.
The installation media is in the is-suite directory.
2. Change to the is-suite directory and run the installation program as root
user by using the following command:
./setup [-verbose]
The -verbose option is optional. The option causes the installation program to
display log messages to the console and also write them to the log file. If the
-verbose option is not specified, log messages are written to the log file only.
Several messages are displayed. The program then displays a message about
how to access the installation wizard:
======> Enter one of the following URLs to your web browser to begin the installation process:
http://localhost:8080/ISInstall
https://localhost:8443/ISInstall
3. Open a web browser on the computer or on a remote computer, and go to one
of the addresses that is listed in the messages from starting the installation
program.
4. Select a language from the menu for the installation program to use and click
Login. This selection applies only to this installation session. Later in the
installation process, you can select the language to apply to the InfoSphere
Information Server installation.
5. Click Next on the prompts in the installation program to continue to install
the product. The installation program runs an Early Requirements Check to
ensure that your installation is configured correctly as shown in the figure:
10 Alcatel-Lucent 5620 SAM LogToFile 2.3.0.0 Technology Pack Installation and User Guide