Troubleshooting guide

3 — NE user and device security
Alcatel-Lucent 5620 Service Aware Manager 3-15
5620 SAM
System Administrator Guide
iii Configure the required parameters.
iv If the Rate Type parameter is set to Kbps, configure the Rate Limit (Kb/s)
and Buffer Space (Bytes) parameters in the Kbps panel. You can specify a
default value for these parameters by selecting the Default check box.
v If the Rate Type parameter is set to Packets, configure the Rate Limit
(packets), Time Limit (seconds), and Initial Delay (packets) parameters in the
Packets panel. You can specify a default value for the Rate Limit (packets)
parameter by selecting the Default check box.
vi Configure the Exceed Action parameter. If you set this parameter to Discard
or Low Priority, configure the Hold Down Duration (seconds) parameter.
vii Click OK. The Static Policer form closes.
5 Repeat step 4 to configure an additional static policer, if required.
6 To configure a local monitoring policer, perform the following steps.
i Click on the Local Monitoring Policer tab.
ii Click Create or choose an entry and click Properties. The Local Monitoring
Policer (Create|Edit) form opens.
iii Configure the required parameters.
iv If the Rate Type parameter is set to Kbps, configure the Rate Limit (Kb/s)
and Buffer Space (Bytes) parameters in the Kbps panel. You can specify a
default value for these parameters by selecting the Default check box.
v If the Rate Type parameter is set to Packets, configure the Rate Limit
(packets), Time Limit (seconds), and Initial Delay (packets) parameters in the
Packets panel. You can specify a default value for the Rate Limit (packets)
parameter by selecting the Default check box.
vi Configure the Exceed Action parameter.
vii Click OK. The Local Monitoring Policer form closes.
7 Repeat step 6 to configure an additional local monitoring policer, if required.
8 To configure protocol mappings for static policers and local monitoring policers,
perform the following steps.
i Click on the Protocols tab.
ii Click Create or select an entry and click Properties. The Protocols
(Create|Edit) form opens.
iii Configure the required parameters.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01