Troubleshooting guide

3 — NE user and device security
3-14 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
Procedure 3-4 To view NE DoS protection violations
1 Choose Administration→Security→NE System Security from the 5620 SAM main
menu. The Select Site form opens.
2 Choose a managed device in the list and click OK. The NE System Security (Edit)
form opens.
3 Click on the NE DoS Protection tab.
4 Perform one of the following to view a specific violation type.
a Click on the Per MAC Source Violations tab to view a list of the violations
associated with subscriber hosts according to MAC address.
b Click on the Per IP Source Violations tab to view a list of the violations
associated with subscriber hosts according to IP address.
c Click on the Link Specific Port Violations tab to view a list of the violations
at the port level. The following kinds of violations are listed:
• violations that exceed the Link Rate Limit (pps) parameter value specified
for the NE
• violations that exceed the Port Overall Rate Limit (pps) parameter value
specified for the NE.
d Click on the Network Interface Violations tab to view a list of the violations
for network interfaces that exceed the Overall Rate Limit (pps) parameter
value specified in an associated NE DoS protection policy.
e Click on the SAP Violations tab to view a list of the violations for SAPs that
exceed the Overall Rate Limit (pps) parameter value specified in an
associated NE DoS protection policy.
5 Repeat step 4 as required to view another violation type.
6 Close the NE System Security (Edit) form.
Procedure 3-5 To configure an NE DDoS protection policy
1 Choose Administration→Security→NE DDoS Protection from the 5620 SAM main
menu. The NE DDoS Protection form opens.
2 Click Create or choose a policy and click Properties. The DDoS Protection Policy
(Create|Edit) form opens.
3 Configure the required parameters.
4 To configure a static policer, perform the following steps.
i Click on the Static Policers tab.
ii Click Create or choose an entry and click Properties. The Static Policer
(Create|Edit) form opens.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01