Troubleshooting guide

3 — NE user and device security
Alcatel-Lucent 5620 Service Aware Manager 3-13
5620 SAM
System Administrator Guide
13 Distribute the filter to NEs, as required.
14 Close the open forms.
Procedure 3-3 To configure an NE DoS protection policy
Perform this procedure to control the amount of subscriber-based control-plane traffic
that NE interfaces receive.
1 Choose Administration→Security→NE DoS Protection from the 5620 SAM main
menu. The NE DoS Protection form opens.
2 Click Create or choose a policy and click Properties. The NE DoS Protection
(Create|Edit) form opens.
3 Configure the required parameters.
4 Perform the following steps to configure CFM frame-rate limiting, if required.
i Click on the CFM Rate Limiting tab.
ii Click Create. The CfmRateLimiting (Create) form opens.
iii Configure the required parameters:
iv Click Add in the Op Code Set panel. The Select Property form opens.
v Choose one or more Op Codes in the list and click OK.
vi Save your changes and close the form.
5 Click Apply to save the changes.
6 Distribute the policy to NEs, as required.
7 Close the open forms.
Note — To perform this procedure, you require an account with an
assigned administrator scope of command role to the sitesec package,
or a scope of command role with write access permission to the sitesec
package.
Note — You must specify at least one Op Code value.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01