Troubleshooting guide

3 — NE user and device security
3-12 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
6 To configure an IPv6 filter entry, perform the following steps.
i Click on the IPv6 Entries tab.
ii Click Create or choose an entry and click Properties. The CPM IPv6 Filter
Entry (Create|Edit) form opens.
iii Configure the required parameters.
iv Click on the Filter Properties tab.
v Configure the required parameters.
vi Save your changes and close the form.
7 Repeat step 6 to configure an additional IPv6 entry, if required.
8 To configure a MAC entry, perform the following steps.
i Click Create or choose an entry and click Properties. The CPM MAC Filter
Entry (Create|Edit) form opens.
ii Configure the required parameters.
iii Click on the Filter Properties tab and configure the required parameters.
If you set the Frame Type parameter to e802dot2LLC, configure the
parameters in the Match Criteria - DSAP SSAP panel.
If you set the Frame Type parameter to e802dot2SNAP, configure the
parameters in the Match Criteria - SNAP panel.
If you set the Frame Type parameter to Ethernet II, configure the Ether Type
parameter.
iv Save your changes and close the form.
9 Repeat step 8 to configure an additional MAC entry, if required.
10 To configure a queue entry, perform the following steps.
i Click on the Queues tab.
ii Click Create or choose an entry and click Properties. The CPM Filter Queue
Entry (Create|Edit) form opens.
iii Configure the required parameters.
iv Click on the CIR/PIR and Burst Size tab and configure the required
parameters.
Ensure that the Committed Burst Size (KB) parameter value is lower than
the Maximum Burst Size (KB) parameter value.
v Save your changes and close the form.
11 Repeat step 10 to configure an additional queue entry, if required.
12 Click Apply to save the changes.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01