Troubleshooting guide

3 — NE user and device security
Alcatel-Lucent 5620 Service Aware Manager 3-11
5620 SAM
System Administrator Guide
If you set the Frame Type parameter to e802dot2SNAP, configure the
parameters in the Match Criteria - SNAP panel.
If you set the Frame Type parameter to Ethernet II, configure the Ether Type
parameter.
v Save your changes and close the form.
8 Repeat step 7 to configure an additional MAC entry, if required.
9 Click Apply to save the changes.
10 Distribute the MAF to NEs, as required.
11 Close the open forms.
Procedure 3-2 To configure a CPM filter
1 Choose Administration→Security→NE CPM Filter from the 5620 SAM main menu.
The NE CPM Filter form opens.
2 Click Create or choose a policy and click Properties. The CPM Filter (Create|Edit)
form opens.
3 Configure the required parameters.
4 To configure an IPv4 filter entry, perform the following steps.
i Click on the IPv4 Entries tab.
ii Click Create or choose an entry and click Properties. The CPM IP Filter Entry
(Create|Edit) form opens.
iii Configure the required parameters.
iv Click on the Filter Properties tab.
v Configure the required parameters.
vi Save your changes and close the form.
5 Repeat step 4 to configure an additional IPv4 entry, if required.
Note 1 — To perform this procedure, you require an account with an
assigned administrator scope of command role to the sitesec package,
or a scope of command role with write access permission to the sitesec
package.
Note 2 — The 7705 SAR does not support queue or MAC CPM filters.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01