Troubleshooting guide

15 — As required maintenance tasks
15-42 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
v Click Choose and use the file browser form that opens to specify the directory
that contains the backup file set.
vi Click Next. The General Database Restore Info panel is displayed.
vii Configure the required parameters in each successive panel until the
Database Restore panel is displayed. Use the values recorded during the most
recent database installation or upgrade, and click Next in each panel to
continue.
viii Click Start Process. The restore process begins.
ix When the Installation Complete panel is displayed, open a separate console
window and run the script specified in the panel.
x When the script execution is complete, click Done to close the installation
utility. The 5620 SAM database begins to initialize.
28 Perform the following steps to enable the primary 5620 SAM main server startup
daemon:
i Log in to the primary main server station as the root user.
ii Open a console window and enter the following:
# cd /etc/init.d ↵
iii Enter the following:
# mv inactive.5620SAMServerWrapper 5620SAMServerWrapper ↵
29 Perform the following steps to start the primary 5620 SAM main server:
i Enter the following to switch to the samadmin user:
# su - samadmin ↵
ii Enter the following:
bash$ cd /opt/5620sam/server/nms/bin ↵
iii Enter the following to start the 5620 SAM server:
bash$ ./nmsserver.bash start ↵
iv Enter the following to check the server status:
bash$ ./nmsserver.bash -s nms_status ↵
Note — You must specify the original database backup directory
verified in step 12.
Note — A 5620 SAM database restore takes considerable time,
depending on the database size.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01