Troubleshooting guide

15 — As required maintenance tasks
15-34 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
viii Click Start Process. The restore process begins.
ix When the Installation Complete panel is displayed, open a separate console
window and run the script specified in the panel.
x When the script execution is complete, click Done to close the installation
utility. The database begins to initialize.
23 Perform the following steps to enable the 5620 SAM main server startup daemon.
i Log in to the main server station as the root user.
ii Open a console window.
iii Enter the following:
# cd /etc/init.d ↵
iv Enter the following:
# mv inactive.5620SAMServerWrapper 5620SAMServerWrapper ↵
24 Perform the following steps to start the 5620 SAM main server.
i Log in to the main server station as the samadmin user.
ii Enter the following:
bash$ cd /opt/5620sam/server/nms/bin ↵
iii Enter the following to start the 5620 SAM server software:
bash$ ./nmsserver.bash start ↵
25 Close the open console windows on each station.
26 When the database restore is complete, perform a full resynchronization of the
network to discover the interim changes in the managed network.
Procedure 15-22 To restore the primary database in a redundant
5620 SAM system
Perform this procedure to restore a 5620 SAM database using a database backup
created on the same station in a redundant 5620 SAM system. The station is called the
primary database station in this procedure.
To regain 5620 SAM database redundancy when the database restore is complete, you
must reinstantiate the restored primary database on the standby database station. See
Procedures 15-23 and 15-24 for information.
Note — A 5620 SAM database restore takes considerable time,
depending on the database size.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01