Troubleshooting guide

15 — As required maintenance tasks
Alcatel-Lucent 5620 Service Aware Manager 15-33
5620 SAM
System Administrator Guide
18 Enter the following to switch to the Oracle management user:
# su - Oracle_management_user_name ↵
where Oracle_management_user_name is the name of the RHEL user with Oracle management
privileges, typically oracle
19 Navigate to the directory that contains the 5620 SAM installation software.
20 Enter the following:
# cd Linux ↵
21 Enter the following:
# ./DBConfig_RHEL_R_r_revision.bin ↵
where
R_r is the release identifier, in the form MAJOR_minor
revision is the revision identifier, such as R1, R3, or another descriptor
The 5620 SAM database installation utility opens, and displays the Introduction
panel.
22 Perform the following steps.
i Click Next. The Software License Agreement panel is displayed.
ii Select the “I accept the terms of the License Agreement” option and click
Next. The Choose Installation Type panel is displayed.
iii Select the “Restore a Database” option and click Next. The Install Oracle
Software panel is displayed.
iv Select the “Do not install Oracle Software” option and click Install. The
installer prepares to restore the database, and then displays the Locate the
Backup Directory panel.
v Click Choose and use the file browser form that opens to specify the directory
that contains the backup file set.
vi Click Next. The General Database Restore Info panel is displayed.
vii Configure the required parameters in each successive panel until the
Database Restore panel is displayed. Use the values recorded during the most
recent 5620 SAM database installation or upgrade, and click Next in each
panel to continue.
Note — You must specify the original database backup directory
verified in step 8.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01