Troubleshooting guide

15 — As required maintenance tasks
Alcatel-Lucent 5620 Service Aware Manager 15-29
5620 SAM
System Administrator Guide
ii Enter the following:
# cd /etc/init.d ↵
iii Enter the following:
# mv 5620SAMServerWrapper inactive.5620SAMServerWrapper ↵
4 Perform the following steps to stop the 5620 SAM database:
i Log in to the database station as the root user.
ii Enter the following:
# cd /etc/rc3.d ↵
iii Enter the following to stop the Oracle proxy daemon:
# ./S965620SAMOracleProxyWrapper stop ↵
iv Enter the following to stop the 5620 SAM database daemon:
# ./S95db5620sam stop ↵
Do not proceed until the command displays the following text string:
Done
5 Perform the appropriate 5620 SAM database uninstallation procedure in the
5620 SAM | 5650 CPAM Installation and Upgrade Guide.
6 Log in to the 5620 SAM database station as the root user.
7 Remove any files that remain in the install_directory/tablespace and
install_directory/archivelog directories
where install_directory is the database installation directory, typically /opt/5620sam/samdb
8 Verify that the database backup file set is in the original backup directory on the
5620 SAM database station. If it is not, copy the backup file set saved in step 1 to
the original backup directory.
9 Open a console window and navigate to the directory that contains the 5620 SAM
installation software.
10 Enter the following:
# cd Linux ↵
Note 1 — Ensure that the Uninstall Oracle Software parameter in the
Uninstall Oracle Software panel is not selected. The Oracle software is
required for the restored database.
Note 2 — Do not perform the final step that describes removing files.
Note — The path to the backup file set must be the same as the initial
path to the file set after backup creation.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01