Troubleshooting guide

15 — As required maintenance tasks
Alcatel-Lucent 5620 Service Aware Manager 15-19
5620 SAM
System Administrator Guide
-- Primary Server is UP
vii On the standby main server, enter the following to start the main server:
bash$ ./nmsserver.bash start ↵
The standby main server starts.
viii Enter the following to check the server status:
bash$ ./nmsserver.bash -s nms_status ↵
The command returns server status information. The main server is
completely started when the command returns the following line of output:
-- Standby Server is UP
ix Close the console window.
x Log out of the standby main server station.
15 If the dbAutoFailOver value recorded in step 3 is yes, perform the following steps:
i Navigate to the /opt/5620sam/server/nms/config directory on the primary
main server station.
ii Open the nms-server.xml file using a plain-text editor such as vi.
iii Locate the following parameter entry:
dbAutoFailOver="no"
iv Edit the entry to read:
dbAutoFailOver="yes"
v Save and close the nms-server.xml file.
vi Navigate to the /opt/5620sam/server/nms/bin directory.
vii Enter the following:
bash$ ./nmsserver.bash read_config ↵
Caution — If the command output indicates that the server is not
completely started, wait five minutes and then repeat the step. Do not
proceed to the next step until the server is completely started.
Caution — If the command output indicates that the server is not
completely started, wait five minutes and then repeat the step. Do not
proceed to the next step until the server is completely started.
Caution — Contact Alcatel-Lucent technical support before you
attempt to modify the nms-server.xml file. Modifying the
nms-server.xml file can have serious consequences that can include
service disruption.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01