Troubleshooting guide

15 — As required maintenance tasks
15-8 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
DCP database is started successfully
Starting 5620 SAM DCP server......
5620 SAM DCP server is started successfully
7 Close the console window.
Procedure 15-5 To test 5620 SAM disk performance
Before you add disk capacity to a component that uses the RHEL LVM function, you must
ensure that the disk throughput and latency values of a new volume are within
tolerance, which is defined as being within 10% of the values for the current volume.
Perform this procedure to check the performance of a 5620 SAM disk partition.
1 Perform one of the following:
a Perform the following steps to shut down a 5620 SAM main server.
i Log in to the main server station as the samadmin user.
ii Open a console window.
iii Navigate to the /opt/5620sam/server/nms/bin directory.
iv Enter the following:
bash$ ./nmsserver.bash force_stop ↵
v Enter the following to display the server status:
bash$ ./nmsserver.bash appserver_status ↵
The command returns a status message.
vi The main server is stopped when the command returns the following
status message:
Application Server is stopped
If the command returns a different message, repeat step v. Do not
proceed to the next step until the server is stopped.
b Perform the following steps to shut down a 5620 SAM auxiliary server.
i Log in to the auxiliary server station as the samadmin user.
ii Open a console window.
Caution — Performing this procedure requires stopping one or more
5620 SAM components. You must perform this procedure only during a
scheduled maintenance period.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01