Troubleshooting guide

15 — As required maintenance tasks
15-4 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
14 Click Done. The installer closes.
15 Close the console window.
Procedure 15-2 To reconfigure a 5620 SAM database after a RAM
upgrade
Perform this procedure after a change in the amount of RAM that is available to the
5620 SAM database.
1 Log in as the root user on the database station.
2 Open a console window and enter the following to stop the 5620 SAM database:
# /etc/rc3.d/S95db5620sam stop ↵
Do not proceed until the command returns the following text string:
Done
3 Enter the following to run the Oracle SGA reconfiguration script:
# /opt/5620sam/db_name/install/config/db_name/SGA_reconfig.sh ↵
where db_name is the name of the 5620 SAM database, typically samdb
The following prompt is displayed:
Enter the password for the "SYS" database user (terminal echo is
off):
4 Type the SYS user password and press ↵.
The following prompt is displayed:
Accept value? [y/n/q] (y):
5 Press ↵ to accept the value, or type n ↵ and return to step 4.
6 The following message and prompt are displayed:
SGA Reconfiguration Triggered for Oracle
Specify whether a 5620 SAM server will be installed on this
Caution — This procedure requires a restart of the 5620 SAM database,
which is service-affecting. You must perform the procedure only during
a scheduled maintenance period.
Note — You require the following user privileges on the database
station to perform this procedure:
• root
• Oracle SYS user
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01