Troubleshooting guide

9 — NE maintenance
Alcatel-Lucent 5620 Service Aware Manager 9-7
5620 SAM
System Administrator Guide
Example details
The example policy settings are the following:
• Auto Save Scheme—Every Nth Successful Deployment
Initiate a device configuration save after the number of configuration changes
specified by Auto Save Threshold.
• Auto Save Threshold—3
Initiate a configuration save after every three successful deployments, if Auto
Save Scheme is set to Every Nth Successful Deployment.
• Scheduled Save Scheme—None
Do not perform a scheduled configuration save on any NE.
• Scheduled Save Interval—1 hour
If scheduled saves are enabled, perform a save every hour.
• Save Details—disabled
Save only non-default parameter values.
• Configuration Save Interval—30 seconds
Delay consecutive configuration save requests for an NE that are less than 30
seconds apart.
• Interval Repeat Limit—5
Wait up to five Configuration Save Interval periods before performing a
configuration save.
• Retry Scheme—Retry Number Of Times
Retry each deployment the number of times specified by Retry Interval.
• Retry Interval—5 minutes
Wait five minutes before retrying a failed deployment.
• Retry Threshold—3
Retry each failed deployment three times.
Sample backup/restore policy configuration
The following example describes a sample 5620 SAM backup/restore policy
configuration and its operation using parameter values that are appropriate for most
applications. The Backup Policy form contains the parameters listed in the example.
See Procedure 9-3 for the configuration information.
Example details
The sample backup policy specifies that the 5620 SAM obtains the backup files by
FTP from the device once every hour regardless of configuration activity, and after
every 25 configuration changes. The policy also specifies that the 5620 SAM backs
up the device configuration file and boot options file (BOF) only when a newer file
is present, and uses gzip file compression. The 5620 SAM is to retain at most 30
backup versions, and purge versions that are more than 30 days old.
The backup policy parameters and their values are:
• Enable Backup—enabled
• Auto Reboot After Successful Restore—enabled
• Scheduled Backup Scheme—Every Scheduled Interval
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01