Troubleshooting guide

7 — 5620 SAM database management

7-6 Alcatel-Lucent 5620 Service Aware Manager

5620 SAM

System Administrator Guide

3 To display the database status of one auxiliary database:

i Log on to the auxiliary database station as the root user.

ii Open a console window.

iii Enter the following:

# /etc/init.d/samauxdb status

iv View the status. If the status is not Up, contact Alcatel-Lucent technical

support for assistance.

4 Close the console window.

Procedure 7-4 To configure the allowed number of Oracle database

As a security precaution, you can configure the allowed number of Oracle database user

Procedure 7-15 for information about how to reset the Oracle database user account.

1 Log in to the 5620 SAM database station as the Oracle management user.

2 Open a console window.

3 Enter the following:

bash$ path/install/config/samdb/SAMDb_security.sh ↵

where path is the 5620 SAM database installation location, typically /opt/5620sam/samdb

The following prompt is displayed:

Enter the password for the "sys" user (terminal echo is off):

4 Enter the Oracle SYS user password and press ↵.

The following prompt is displayed:

Accept value? [y/n/q] (y):

5 Perform one of the following.

a Press ↵ to confirm that the supplied password is correct.

The following prompt is displayed:

Note 1 — In a redundant deployment, you must perform this procedure

on the primary database station. After you perform the procedure, the

primary database automatically copies the configuration change to the

standby database.

Note 2 — The configuration changes that you make in this procedure

are not affected by subsequent database upgrades.

Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01