Troubleshooting guide

5 — 5620 SAM component configuration
5-36 Alcatel-Lucent 5620 Service Aware Manager
5620 SAM
System Administrator Guide
Policies tab
Allows you to display or hide the policy names on policy configuration forms for the
following:
• Access ingress and access egress policies
• ACL IP, ACL IPv6, and ACL MAC policy filters
5620 SAM User Guide
Allow you to set a restriction in the distribution mode for certain types of local policies
that will permit local editing only. Additionally, the following applies to this system
preference configuration:
• Policy types supported by this system preference include Access Ingress, Access
Egress, Network QoS, ACL MAC, ACL IPv4, and ACL IPv6.
• When creating any of these policies, if you set the Scope parameter to exclusive, the
5620 SAM will set the distribution mode to local edit.
• The 5620 SAM will not allow policies with the Scope parameter set to exclusive to be
assigned or used more than once.
• If you attempt to set the Policy Distribution Mode to Sync With Global while the
Scope attribute is configured as exclusive, an error message will result.
Allow you to specify that for policy changes made using CLI, to switch the distribution
mode for certain types of local policies to Local Edit Only, as opposed to the default Sync
with Global mode.
Allows you to configure the automatic distribution of a global policy to applicable NEs
once the policy is released.
Allows you to configure the maximum number of scheduled audit results stored for a
local policy.
Allows you to enable or disable if all zones are resynchronized from the node as local edit
only. If you disable the Discover Security Zone in Local Edit Only parameter, all zones
resynchronized from the node are set to Sync With Global.
• The Discover Security Zone in Local Edit Only parameter is only supported on the
7705 SAR-8 with CSMv2, 7705 SAR-8v2 with CSMv2, 7705 SAR-18, 7705 SAR-H,
7705 SAR-Hc, and 7705 SAR-Wx variants, Release 6.1 R1 or later.
Custom NE Properties tab
Allows you to configure if custom property labels and values are used to identify an NE,
for example, the location and site name that differs from the actual NE site name. These
properties cannot be configured on the NE. Additionally, the following applies to this
system preference configuration:
• If custom property labels are not configured, the default labels are used.
• NE custom properties support the extended character set including multi-byte
characters.
• Custom property labels and values are displayed in the following locations:
• NE Properties form
• NE List form
—
ESM tab
Allows you to configure the default behavior associated with the on-demand retrieval of
residential subscriber-related information from NEs such as:
• The tracked subscriber retrieval timeout interval
• The subscriber host retrieval timeout interval
• The maximum number of residential subscriber instances returned via OSS
• If managed route information should be collected
• If QoS override information should be collected
• If SLAAC host addresses should be collected
• If access loop encapsulations should be collected
• If BGP peer information should be collected
5620 SAM User Guide
Function or setting Additionally see
(3 of 4)
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01