Troubleshooting guide

3 — NE user and device security
Alcatel-Lucent 5620 Service Aware Manager 3-31
5620 SAM
System Administrator Guide
Procedure 3-18 To configure an NE management access firewall on
the 7705 SAR-H
Perform the following procedure to configure a firewall using the management access
interface.
1 Choose Administration→Security→NE Firewall→NE Management Access Firewall
from the 5620 SAM main menu. The NE Management Access Firewall form opens.
2 Perform one of the following:
a To create a firewall, click Create. The Management Access Firewall (Create)
form opens.
b To modify a firewall, click on the search button to display a list of firewall
entries. Choose an entry from the filtered list and click Properties. The
Management Access Firewall (Edit) form opens.
3 Configure the required parameters.
4 Create one or more firewall entries.
i Click on the Firewall Entries tab.
ii Click Create. The Firewall Entry (Create) form opens.
iii Configure the required parameters.
iv Click Select and choose a zone.
v Select the IP Operator check box from the IP Address panel on the Firewall
Entry (Create) form.
vi Choose one of the following from the IP Operator drop-down menu and enter
the range, if required:
• EQUAL
• RANGE
vii Save and close the form.
5 Save and close the form.
Caution — If the zone entry using the Management Access Firewall on
the 7705 SAR-H is not properly configured, the essential communication
channel between 5620 SAM and the NE could be terminated. It is
advisable to check before turning up the Management Access Firewall
that protocols such as UDP, ICMP, SSH, TFTP, FTP, TELNET, SCP, and
NTP are not blocked.
Note 1 — The NE management access firewall function is supported
only on a Release 5.0 or later 7705 SAR-H.
Note 2 — You cannot attach a zone containing a ruleset that has a
firewall log with destination as syslog to the management access
firewall.
Release 13.0 R2 | May 2015 | 3HE 09815 AAAB TQZZA Edition 01