Specifications

5
If you are testing after the POTS splitter at the customer pre-
mises, you will need to address a different connection config-
uration. The POTS splitter is used to separate the ADSL
signal from the POTS signal. Before the POTS splitter
(toward the ATU-C), the combined ADSL/POTS signal is car-
ried over pins 4 and 5 for 8 pin connections or pins 3 and 4 for
6 pin connections. After the POTS splitter (toward the ATU-
R), the ADSL signal is carried over pins 3 and 6 for 8 pin con-
nections or pins 2 and 5 for 6 pin connections. See Figure 3.
Figure 3. Diagram of RJ-11 Pin In/Out
System Configuration
Turn the TS1000 on and move the cursor (*) to the “System
Config” option. Press the right arrow key to view TS1000’s
configuration.
RJ-11 Network
Connection
at NID
RJ-11 CPE Connection
in the Customer Premises
after the Splitter
Pins 3 & 4
contain both POTS
and ADSL signals
Pins 3 & 4 contain POTS
and pins 2 & 5 contain
the ADSL data signal
1 2 3 4 5 6 1 2 3 4 5 6
Note: G. Lite will have both voice and data
terminated on the center two pins.
ts1000_003
Menu Menu B: 90%
View Results
*System Config
Press to view
ts1000_004