Specifications

11
ITU rev.#: Displays the ITU Standard revision number. This
result will only appear if the manufacturer’s ATU-C supports this
feature.
Care must be taken when interpreting results since many
factors must be considered. These include time of day,
effect of impulse noise, ATU-C setup parameters. See sec-
tion on Error Messages should an error message occur.
Once the TS1000 received all the results from the Alcatel com-
patible ATU-C, the unit will release the line by sending a “Dying
Gasp” command to the ATU-C. This is a command that instructs
the ATU-C that the ATU-R (TS1000) is disconnecting from the
line and the ATU-C should not indicate an alarm. The “Dying
Gasp” message may not be sent instantaneously after the last
result was collected. This will depend upon the time limit set for
Connection time under the Setup menu option. See the Config-
uring Tests section for additional information. The user can stop
a running test if the Connection Time is greater than 0 seconds.
By scrolling through the result screens, rather than seeing the
command “Press > to Save”, the user will see “Press < to stop”.
Press the left arrow key once to stop the test. The option now
becomes “Press > to save”.
Saving and Printing Results
After conclusion of a test, the user can scroll to the bottom of
the results screen to access the Saving and Printing functions.
Pressing the right arrow key on the TS1000 will display the fol-
lowing screen.
Result: Dwn Up
Atten : 2.0 1.0
Op. Mode: ANSI
Press to stop
ts1000_013
Result: Dwn Up
Atten : 2.0 1.0
Op. Mode: ANSI
Press to save
ts1000_010