Specifications

9
There is a possibility to have one more screen appear on the
TS1000 after the Op.Mode: result. This is entirely dependent
upon whether or not the ATU-C has been provisioned to provide
information such as Vendor ID or Provider code. By pressing
the down arrow key one more time, this last screen can be dis-
played, if applicable.
If the Op.Mode: is ANSI, then the following information is pre-
sented.
If the Op.Mode is either G.DMT or G.LITE, then the following
information is presented.
The left column of results designates the downstream results
(from the ATU-C to the Customer Premise). The right column of
results designates upstream results (from the Customer
Premise to ATU-C). For an explanation of the “Press -> to Save”
option, see the section titled Saving and Printing Results.
Note: As soon as the TS1000 receives all the results from
the Alcatel ATU-C, the unit will send a "Dying Gasp" com-
mand to the ATU-C. This is a command that instructs the
ATU-C that the ATU-R (TS1000) is disconnecting from the
line and the ATU-C should not indicate an alarm.
The results obtained are indicated below:
MaxB/R: Displays the maximum attainable bit rate. Results are
presented in kbits/s. The measured values for upstream and
downstream should be greater than or equal to the minimum
bit rate set in the ATU-C.
B/Rate: Displays the achieved fast bit rate. Results are pre-
sented in kbits/s. The measured values for upstream and down-
stream should be greater than or equal to the minimum bit rate
set in the ATU-C. The result will be 0 if Interleaved Bit Rate is
turned on in the ATU-C.
Vendor ID: 0x22
Press to save
ts1000_011
Prov: Oxf f f f f f f f
Spec. Info: Oxf f f f
ITU rev. #: 0xf f
Press to save
ts1000_012