User Guide

Adding CIP members
Result
10 Configuration and Use - CIP & IP Routing
113 / 238
3EC 17059 ABAA TCZZA Ed. 01
Proceed as follows:
1. Browse to the 'CIP' page.
Addition of a CIP member is performed in the 'CIP Interfaces'
table.
2. Fill in the following CIP member parameters:
 Local IPaddress
The IP address of the CIP member at your local side of
the LIS.
 Mask
The associated netmask/subnetmask for this local IP
address.
3. Click
and to finish the procedure.
A CIP member of the LIS is created at your STPro's CIP interface
side of the LIS. The local IP address is added to the 'IP Address'
table.
Two default routes are added to the 'IP Route' table, both pointing
to the STPro as gateway, but the first with the CIP member itself as
destination, the second with the LIS subnetwork IP address pool as
destination.