User Guide

Routed PPPoE
configuration
Opening dialin PPPoE
sessions
9 Configuration and Use - Routed PPPoE
73 / 288
3EC 36231 ABAA TCZZA Ed. 01
9.2 Using Routed PPPoE
There are no default Routed PPPoE entries.
Therefore, configure the appropriate as follows:
1. If needed, add an ETHoA phonebook entry with the correct
VPI/VCI on the 'Phonebook' page.
2. On the 'PPP' page, select this phonebook entry from the
'Address' popdown list.
3. For this entry, select PPPoE in the 'Protocol' field.
4. Select the correct encapsulation method from the
'Encapsulation' popdown list.
5. Optionally, enter username and password.
6. Click
.
7. Optionally perform detailed configurations.
See section 9.3 for more information.
Proceed as follows (See section 21.2 for more information):
1. Click
on the STPro pages.
2. On the 'Dialin' page the following table is shown:
3. Click next to the PPPoE entry you want to connect with. As
a result your selection is highlighted (See example above).
4. Click
.