User Guide
Introduction
Bridging configuration
8 Configuration and Use - Bridged PPPoE
70 / 288
3EC 36231 ABAA TCZZA Ed. 01
8.3 Bridged PPPoE Configuration
As the Bridged PPPoE packet service implies nothing more than
using the STPro Transparent Bridging packet service, no specific
configuration for Bridged PPPoE is required on the STPro.
However, you may need to configure the Transparent Bridging
packet service of the STPro in order to meet the requirements of
your SP regarding VC(s) and encapsulation.
There are no default Bridging entries.
Therefore, configure an appropriate entry as follows:
1. If needed, add an ETHoA phonebook entry with the correct
VPI/VCI on the 'Phonebook' page.
2. On the 'Bridge' page, select this phonebook entry from the
'Address' popdown list.
3. For this entry, select the correct encapsulation method (per
default set to LLC/SNAP).
4. Click
.
See section 6.3 for more information.