User Guide
Adding entries
Deleting entries
7 Configuration and Use - Routed Ethernet
66 / 288
3EC 36231 ABAA TCZZA Ed. 01
Field Description
MAC Address Indicates the MAC address for the Routed Ethernet entry.
Note: In case no MAC address is entered manually, the
source MAC address of the Ethernet frames is the STPro
Ethernet MAC address.
NAT Indicates whether NA(P)T is used () or not on the IP address
of the Routed Ethernet entry.
DHCP Indicates whether DHCP is used () or not for the Routed
Ethernet entry.
(*) Ethernet frames are also referred to as Medium Access Control (MAC)
frames or IEEE802.3 frames.
Proceed as follows:
1. Browse to the 'MER' page.
2. If needed, click
.
3. Select the phonebook entry from the 'Address' popdown list.
Note: In case the presented phonebook entries do not suite your desired
configuration, you must firstly create a correct phonebook entry. See
section 13.3 for more information.
4. Select the encapsulation method for the Bridging port from
the 'Encapsulation' popdown list (per default set to
LLC/SNAP).
5. Optionally, enter the appropriate configuration in one, or
more of the following fields:
The 'Interface' field
The 'IP Address' and 'IP Netmask' fields
The 'MAC Address' field.
6. Optionally, check one or more of the following checkboxes:
The 'NAT' checkbox
The 'DHCP' checkbox.
7. Click
and to finish the procedure.
On the 'MER' page, click next to the entry you want to delete.
As a result your selection is highlighted.
Click
and .