User Guide

The 'MER Settings'
table
'MER Settings' table
components
7 Configuration and Use - Routed Ethernet
65 / 288
3EC 36231 ABAA TCZZA Ed. 01
The following figure shows the 'MER Settings' table:
Field Description
Intf
Interface
Indicates the interface name for the Routed Ethernet entry.
Note: In most cases, the interface name will be the same as
the phonebook entry name.
Address Indicates the phonebook entry used by the Routed Ethernet
entry.
State
Indicates the state of the Routed Ethernet interface.
Note: Unless the interface is created via the CLI, Routed
Ethernet entries are always in state connected.
Encap
Encapsulation
Indicates the applied encapsulation method for Ethernet
frames(*) on the VC.
The STPro supports both the LLC/SNAP method (default) and
the VCMUX method.
FCS Indicates whether the last four bytes of the Ethernet frames
are preserved or not. By default the FCS is set to NO.
Note: You can set the FCS to YES via the CLI.
IP Address
IP Netmask
Indicates the negotiated IP address and netmask used by the
Routed Ethernet entry.
In case DHCP is checked () this IP address is dynamically
assigned by the remote DHCP server. If DHCP is unchecked,
you must enter a static IP address for the local side of the
Routed Ethernet connection.