User Guide

Introduction
In this section
Telnet features
Telnet requirements
22 Maintenance - Speed Touch CLI
252 / 288
3EC 36231 ABAA TCZZA Ed. 01
22.2.1 CLI through a Telnet Session
Via a PC or terminal connected to the Ethernet interface of the
STPro you can execute CLI commands.
However, you must gain access to the STPro first by opening a
TCP/IP Telnet session.
 Telnet Features
 Telnet Requirements
 Using a Telnet Session to your STPro.
Telnet is:
 A fairly general, bidirectional, eightbit byteoriented
communication facility
 A standard method of interfacing terminal devices to each
other.
Prior to using Telnet, you need:
 A connected and configured STPro, with known IP address or
DNS hostname
 If applicable, the system password for accessing the STPro
 A PC or terminal connected to the LAN
Note: LAN is referred to as a network containing at least one PC or
terminal, and your STPro.
 A TCP/IP suite installed on this PC or terminal
 A Telnet session application installed on this PC or terminal.