User Guide

Introduction
Procedure
20 Maintenance - Speed Touch ToDefaults
238 / 288
3EC 36231 ABAA TCZZA Ed. 01
20.2.3 SwitchtoDefaults
At the back of the STPro there is a set of DIP switches labeled
"Config".
Via these switches a hardware reset of the STPro, the
SwitchtoDefaults, is possible.
Proceed as follows:
1. Make sure your STPro is turned on.
2. Put DIP switch number 4 in the UP position:
Config Console
You will notice that the PWR/Alarm LED flashes amber.
3. Power cycle the STPro and wait to allow the POST to end.
The STPro will come online with manufacturing defaults.
4. Reset the DIP switch in its original position. If not, the
'PWR/Alarm' LED will flash amber as a warning.
5. After a reset to original defaults a reconfiguration of STPro's
IP address might be necessary. This because the reset to
defaults also resets your STPro's IP address to its default value
10.0.0.138.
DIP Switch Position
Leaving the DIP switch in the UP position, will cause unintended
reset to manufacturing defaults !
CAUTION