User Guide

Overview of the
ToDefaults methods
In this section
20 Maintenance - Speed Touch ToDefaults
235 / 288
3EC 36231 ABAA TCZZA Ed. 01
20.2 Speed Touch Reset
To restore STPro's original settings, three methods are provided:
 Two local software methods:
 BrowsetoDefaults
Which sets all parameters to original defaults, but keeps
the system password and IP address.
 PingtoDefaults
Which sets all parameters to original defaults, including
the system password and IP address.
 One hardware method:
 SwitchtoDefaults.
Which sets all parameters to original defaults, including
the system password and IP address.
Restoring Original Settings
Be careful when using ToDefaults procedures as these destroy
changes you previously made to the STPro internal settings.
A reset to defaults via a PingtoDefaults or via a
SwitchtoDefaults also implies the STPro's IP address is reset to
10.0.0.138. As a consequence, IP connectivity with the STPro
could be lost. In that case you must execute a PingofLife.
Topic See
BrowsetoDefaults 20.2.1
PingtoDefaults 20.2.2
SwitchtoDefaults 20.2.3
CAUTION