User Guide

The 'Default server'
table
16 Network Security - NAT & PAT
203 / 288
3EC 36231 ABAA TCZZA Ed. 01
Field Description
Outside IP
Outside port
Outside
address
Indicates the IP address and port on which to perform NAT.
Using 0 as IP address causes a template to be created, which
will be valid for every one of STPro's NAT enabled IP
addresses.
The 'Outside address' field indicates both IP address and
port as IP:PORT.
Note: The outside port must only be specified for the TCP
and UDP protocols. All other protocols do not need a port to
be specified.
Protocol Indicates the protocol of the traffic expected to be received on
the inside IP:PORT.
State Indicates the state of the NAT entry.
The following figure shows the 'Default server' table:
This field allows you to specify a default server. All incoming
connections will be forwarded to the device with this IP address. In
most cases this setting should be adequate for most server
applications.