User Guide
Adding specific routes
to the 'IP route' table
Criteria for a route to
be valid
14 Networking Services - IP
186 / 288
3EC 36231 ABAA TCZZA Ed. 01
Proceed as follows:
1. If needed, click
in the 'IP Route' table.
2. Enter the following route information:
'Destination' IP address (pool) of the destination or
nexthop" device in prefix notation
Specifying default indicates that all outgoing traffic is
sent over this route.
'Source' IP address (pool) in prefix notation
Specifying any indicates that all traffic coming from the
Ethernet interface is sent over this route.
'Gateway' IP address of a directly connected gateway
device, e.g. the STPro itself.
3. Click
. As a result the route is applied.
4. Click
to store the routing configuration to
permanent storage.
A route is only accepted by the STPro if it meets following
conditions:
The destination and source entries must yield correct prefixes
The gateway must be directly connected.