User Guide

Configuring the STPro
as DHCP server
Configuring the STPro
for Auto DHCP
14 Networking Services - IP
172 / 288
3EC 36231 ABAA TCZZA Ed. 01
To setup the STPro as DHCP server, tick .
Via the 'DHCP Server Configuration' table you can configure the
STPro DHCP server settings.
IP Address
STPro DHCP
Server
Internet
Access Point
ATM
Network
Note: This setting might cause side effects with Bridging. See section 14.2.1 for
more information.
One of the STPro features is that it can automatically revert from
DHCP client to DHCP server.
At boot time the STPro probes the LAN for a specified time limit
('Client timeout') to check whether another DHCP server is
available on the network. If so, it will act as a DHCP client. If no
response is received within the specified time, the STPro becomes
a DHCP server.
To allow the STPro to act as Auto DHCP client/server, tick
on the 'DHCP Server' page.
Additionally, you can configure the 'Client timeout' in seconds:
.
Via the 'DHCP server configuration' table, you can configure the
STPro DHCP server settings.