User Guide

Setting an IP address
via the 'Routing' page
14 Networking Services - IP
167 / 288
3EC 36231 ABAA TCZZA Ed. 01
Proceed as follows:
1. Click
in the left pane of the STPro pages to pop up
the 'Routing' page (See section 21.2 for more information).
On this page the following table can be found:
2. In this table If needed, click .
3. Enter the following information:
 Select eth0 from the 'Intf' popdown list
 Enter an IP address in the 'IP Address' field, e.g.
192.6.11.150
 Enter an associated (sub)netmask in the 'Netmask' field,
e.g. 255.255.255.0
 Select whether NA(P)T must be applied (pat) or not (none)
for this IP address from the 'Translation' popdown list.
4. Click
. As a result the new IP settings are applied:
5. To verify connectivity, point your Web browser to the new IP
address. Make sure your PC shares the same subnet.
6. Click
to store the applied IP settings to permanent
storage.