User Guide

Default STPro IP
address
In this subsection
Setting an IP address
via the 'Initial Setup'
page
14 Networking Services - IP
166 / 288
3EC 36231 ABAA TCZZA Ed. 01
14.3.2 Static IP Address Configuration
In case you add the STPro to an existing LAN, it could be that you
must configure a User Defined" IP address other than the default
Net 10" address, appropriate for the LAN's IP settings.
 Setting an IP Address via the 'Initial Setup' Page
 Setting an IP Address via the 'Routing' Page.
Proceed as follows:
1. Click
in the left pane of the STPro pages to pop up
the 'Initial Setup' page (See section 21.2 for more
information). On this page the following table is shown:
2. Enter an IP address in the 'IP Address' field.
3. You must configure a netmask for applying subnetting in your
network in the 'Subnetmask' field.
4. Click
. As a result the new IP settings are applied:
5. To verify connectivity, point your Web browser to the new IP
address. Make sure though that your PC shares the same
subnet.
6. Click
to store the applied IP settings to permanent
storage.