User Guide

Assigning CIP PVCs to
CIP members
Deleting CIP entries
12 Configuration and Use - CIP & IP Routing
136 / 288
3EC 36231 ABAA TCZZA Ed. 01
Proceed as follows:
1. Browse to the 'CIP' page.
Assignment of a CIP PVC is performed in the 'CIP
Connections' table.
2. If needed, click
in the 'CIP Connections' table.
3. Select the phonebook entry from the 'Destination' popdown
list.
You must use a IPoA or any type" phonebook entry for CIP
connections.
Note: In case the presented phonebook entries do not suite your desired
configuration, you must firstly create a correct phonebook entry. See
section 13.3 for more information.
4. Depending the RFC1577/RFC2225 compliancy of the remote
access router the following must be entered in the 'Remote
address' field:
Compliancy Remote IP address
YES You don't have to fill in anything; the InATMARP reply will
implicitly assign the PVC to the CIP member.
NO You must fill in the exact IP address of the remote access
router; the PVC is explicitly assigned to the CIP member.
5. Click and to finish the procedure.
On the 'CIP' page, click next to the CIP connection or CIP
interface you want to delete. As a result your selection is
highlighted.
Click
and .