User Guide

Adding CIP members
Result
12 Configuration and Use - CIP & IP Routing
135 / 288
3EC 36231 ABAA TCZZA Ed. 01
Proceed as follows:
1. Browse to the 'CIP' page.
Addition of a CIP member is performed in the 'CIP Interfaces'
table.
2. If needed, click
in the 'CIP Interfaces' table.
3. Enter in the following CIP member parameters:
 Local IP address
The IP address of the CIP member at your local side of
the LIS.
 Mask
The associated classful or classless netmask/subnetmask
for this local IP address.
4. Click
and to finish the procedure.
A CIP member of the LIS is created at your STPro's CIP interface
side of the LIS. The local IP address is added to the 'IP Address'
table.
Two default routes are added to the 'IP Route' table, both pointing
to the STPro as gateway, but the first with the CIP member itself as
destination, the second with the LIS subnetwork IP address pool as
destination.